Shure PSM200 In Ear System

Shure PSM200 In Ear System


Allows you to hear the music via your earphones at the exact time it is played.
Professional in ear personal monitoring

Key Points
  • EP2T TransMixer
  • P2R Receiver
  • SE112 Earphones
  • Built-in audio limiter

  
Manufacturer: Shure
Availability: Check Stock On 01524 410202
Discount Price: £449.00
Share |

BUY IT NOW FOR £449.00 Add to Cart

Shure PSM200 In Ear System

Allows you to hear the music via your earphones at the exact time it is played.

The entry to professional in ear personal monitoring from Shure. This package contains SE-112 Sound Isolating earphones, a P2R receiver and a P2T transmixer.

The entry to professional in ear personal monitoring from Shure containing all the components you need.

Why is in ear monitoring more effective than using a wedge speaker on stage?

Using a Shure monitoring system allows you to hear the music via your earphones at the exact time it is played. There can be a short delay in music coming out of the wedge, which can cause performers to play out of time. Wedge monitors will sound fine when standing in one position, but if you move to the left or right, that sound is likely to change. With in ear personal monitoring, the sound will be constant and comes with you, wherever you go. Using wedge monitors long term can also be damaging to your ears. Using Shure sound isolating earphones cuts out the sound around you leaving you to focus on playing in time.

 

How do I set up my PSM 200 in ear system?

Simply connect two line-level or mic–level inputs directly into the transmixer. Set the frequency on the transmixer using a single button, and the same again on the bodypack receiver. Connect your earphones to the P2R, set up your desired mix using the personal mix controls on the front of the transmixer and you are now all ready to go.
 

  •     Built-in audio limiter
  •     Front mounted antenna
  •     Two mic/line input channels for mix control
  •     Built in headphone limiter
  •     Volume control on bodypack receiver
  •     1/2 Rack space




    RF Output Power: 10 - 30 mW (countryspecific)
    Operating Distance: Up to 100m
    Harmonic distortion: 1.5 % typical
    Signal-to-noise-ratio: 80 dB (A) typical
    Listening mode: Mono
    Compatible Systems per band (up to): 4
    Transmitter Inputs: 2x XLR/6,3 mm combo, mic/line level
    Transmitter Outputs: 2x XLR split outputs
    Wired Bodypack Option: Yes
    Personal Mix Control: On transmitter
    Remoteable Transmitter: No
    Battery Life: Wired: 6 h; Wireless: 4 h
    Frequency Response: 30 Hz - 12 kHz

    Further technical specifications:

    PSM®200 System

        RF Carrier Frequency Range: 518­-865 MHz (country dependent)
        Modulation: FM +/- 35 kHz Deviation (Nominal)
        Operating Temperature: -7 degrees C to +49 degrees C (+20 degrees F to +120 degrees F)

    EP2T TransMixer
        Modulation Limiter: Internal peak limiter (>10:1 hard knee compression)
        Antenna: 1/4 Wavelength, semi-rigid, PCB Mount
        Connector Type: XLR/1/4-inch combo
        Nominal Input Level: - 25 dBu @ 1/2 volume (12 o'clock)
        Maximum Input Level: - 5 dBu @ 1/2 volume (12 o'clock)
        Current: 170 mA maximum
        Dimensions: 220 mm x 140 mm x 40 mm (8.6 in. x 5.6 in. x 1.7 in.)
        Net Weight: 370 g (13 oz.)

    P2R Receiver
        RF Sensitivity: 109 dBm typical
        Squelch Threshold: 102 dBm typical
        Antenna: Attached Whip
        Audio Input Connector: Connector Type: 1/4-inch Mono
        Impedance: 1 megohm
        Maximum Input Level: LO = +0 dBu; HI = 10 dBu
        Frequency Response: 30 Hz to 20 kHz (+/ 3 dB); earphone dependent
        Power Requirements: 9 V alkaline battery, Duracell® type MN1604 recommended
        Audio Output Connector: 1/8 inch (3.5 mm)
        Minimum Load Impedance: 8 ohms
        Net Weight: 100 g (3.52 oz.), less battery
        Overall Dimensions: 122 mm x 73 mm x 32 mm (4.809 in. x 2.875 in. x 1.251 in.)

     SE112 Earphones
        Frequency Range: 25Hz – 17.5kHz
        Sensitivity: 108 dB SPL/mW (@ 1kHz)
        Impedance: 16 Ohms (@ 1kHz)
        Input Connector: 3.5mm (1/8”)
        Colour: Gray
        Cable Length: 127 cm (64”)




Important Note
Price errors and omissions excepted - An order is considered finalised on dispatch. No monies are debited from your card until the item is in stock or by prior arrangement.

#
Shop by Brand
The Store
sagepay